End Zone Water Injection As A Means Of Suppressing Knock In A Spark Ignition Engine

Download or read book End-zone Water Injection as a Means of Suppressing Knock in a Spark-ignition Engine written by Rinaldo J. Brun and published by . This book was released on 1944 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: Summary: An investigation has been made of the effectiveness of water injection into the combustion end zone of a spark-ignition engine cylinder for the suppression of knock. Pressure-time recoreds obtained show that injection of water at 60° B.T.C. on the compression stroke at a water-fuel ratio of 0.3 rendered M-3 fuel as good as S-3 fuel from an antiknock consideration. The optimum crank angle for injection of water into the end zone was found to be critical. As the injection angle was increased beyond the optimum, the quantity of water required to suppress knock increased to 3.6 water-fuel ratio at 132° B.T.C. The water quantity could not be increased beyond 3.6 water-fuel ration because of injection-pump limitations; however, a further increase in the injection angle up to the earliest angle obtainable, which was 20° A.T.C. on the intake stroke, continuously increased the knock intensity. The engine operating conditions of the tests did not simulate those encountered in flight, especially with regard to the operating speed of 570 rpm. For this reason the results should only be regarded as of theoretical importance until further investigation has been made.